Picoscope 5444D-034 not recognised

Post any questions related to the new PicoScope 7 software
Post Reply
BlackPudding
Newbie
Posts: 0
Joined: Wed Jan 31, 2024 9:05 am

Picoscope 5444D-034 not recognised

Post by BlackPudding »

We have just purchased a 5444D-034 device, initially for use with Vector products (.scope option).

If I try to use this device in Picoscope 7 (Automotive), it says the device is not supported.

If I look up this device in the downloads section (non-automotive), it recommends 'PicoScope 7.1.19 (64-bit)' - if I download this T&M version, the device is not recognised nor are there any messages to say that it is not supported.

Is this device only suitable for being used with the Vector .scope tool or is something else wrong here?

TIA
Post Reply