PicoScope 7 Software
Available on Windows, Mac and Linux
New to Picolog
New to Picolog
Hi all. Im new to piclog tech. Ive recently brought the Cm3 data logger and cant for the life of me get it to connect through ethernet. How do i find what ip address i should be using or port number. ive tried the user manuals but still no joy. Ive read somewhere that theres on ip programme in the programme files but i cant seem to see it. Any help and advice would be much appreciated. 
Re: New to Picolog
You did connect it to a POE capable switch.
A normal switch or a direct connection to laptop or PC will not work.
Benno
A normal switch or a direct connection to laptop or PC will not work.
Benno
Re: New to Picolog
This is for a PT104 but the same applies for the CMS.
Open PicoLog 6 and then on the picture of the device clcik the 3 dots, and then select Device Information which will bring up the following panel where you can set up the ethernet address for the CM3
Chose an address and port that is accessible on your network
Then select the COG on the left hand side of the software
and ensure that ethernet is enabled for CM3
Finally the device will need to be connected and powered over ethernet using POE, or connected but also powered by the USB port.
Open PicoLog 6 and then on the picture of the device clcik the 3 dots, and then select Device Information which will bring up the following panel where you can set up the ethernet address for the CM3
Then select the COG on the left hand side of the software
Finally the device will need to be connected and powered over ethernet using POE, or connected but also powered by the USB port.
Martyn
Technical Support Manager
Technical Support Manager