As far as I know you do the conversion calculation in your own software.

Benno

I have never seen a active probe that outputs more than +/- 5V

But don't expect to measure accurate mv Values at a 1:500 or 1:100 probe.
If you want to measure low voltages with a floating differential probe there are special versions for low voltages that do 1:1 or 10:1 or even 100:1.

Benno

Yes you can add custom probes. There is probably already a profile for this probe and if not you can make it in 2 minutes. And it display's the correct values even the special measurements use the correct values.

Benno

Between 6 and 24 hours depending on the quality of the battery.
This is also true for the different brands (Fluke Rigol etc)

Benno

The current sensor has no phase shift only a propagation delay. I have attached a psdatafile for 12A pulse measurements delays between 1. Shunt resistor (no delay of course) 2. Fluke 80i-110s current probe 3. Hantec CC-65 4. Pico TA300 All are on the correct values after about 10uS. When you are ...

This has been a feature request for a time now but still not implemented.

Benno

That type of probe is asking to kill your scope when using that amount of power.
Use a HV differential probe to measure on mains voltage devices.

Benno

what frequency range do you expect from the function gen ?
because the 2000 can only do 100kHz or 1MHz depending on the model type.

Benno

I don't know the USB3 limitations of the 5443D but you will probably also running into problems with python. Handling 500MB of data a second in python is only possible if you have the fastest pc there is to find. And I don't think the scope can stream at 500MB / second 62.5 Ms * 2 Bytes * 4 = 500MB ...

you have the .psconfig files that does exactly this.
the only is you need to load them so a couple of clicks
run them and then picoscope opens with the config you want. (except the 4444)

Benno

You did connect it to a POE capable switch.
A normal switch or a direct connection to laptop or PC will not work.

Benno

isn't there a calibration conversion in somewhere between raw raw ADC and Voltage value.

Benno

You can use one of the standard other scaling probes.

and then x10 or x100 depending on the switch on the TA041

It is not auto detect you need to configure the probe at the channel in picoscope.

In the clip is a TA511 used that is auto detect the one you have is manual configure.

Benno

You know this has no added value, maybe expect the times. If you have a 8 bit scope 2000 3000 series then there are 256 distinct values between your max settings. So if you use +/- 20V you have a total swing of 40V / 256 = 0.156V per bit. So in that range the smallest difference the scope can ...